User Manual

Install the SST Programming Software
and click
Next
.
In the following Software Setup screen, click
Next
and follow the on-screen instructions. At this
point you will be asked to install such features as the Saitek Magic Mouse, HID-compliant
mouse, Saitek Magic Keyboard and HID Keyboard Device (these are what XP calls the various
elements of your Saitek controller). Continue to click on
Next
and
Finish
to accept the
installation until the Registration screen appears.
At the Registration screen, select
Check this box to register now
and follow the on-screen
instructions, or do not select this option and register later.
Upon completion of the installation, you have the option to
Run Profile Editor
, which will give
you a view of the 3D programming environment. If you do not wish to see the Profile Editor at
this point, just uncheck the box and click on
Finish
to complete the installation.
Installation for Users of Windows® 2000
A) Drivers Only For Typical Users
1. With your computer switched on, close down any programs that are currently running
and insert the Saitek Smart Technology CD into your CD-ROM drive.
2. When the Introduction Screen appears, click
Install Software
to continue. If the CD does
not run automatically, select
Start
from the Windows® Taskbar, then
Run
and type
D:\Setup.exe
and click
OK
- where D:\ is letter of your CD-ROM drive.
3. When the Welcome screen appears, click
Next
to continue.
4. After reading the Disclaimer, select the
I accept the terms of the Disclaimer
option and
click
Next
to continue.
5. At the Device Driver Installation screen, click on
Next
and follow the on-screen
instructions.
6. When prompted, plug the USB cable of your docking station into one of your computer’s
USB ports and click on
Configure
.
7. When the Controller Properties screen appears, click
Next
to view the Test screen.
8. Now try out all your controller’s buttons and controls to show that it is working properly.
When you have finished, click
OK
.
9. At the Programming Software screen, select
Typical User
and click
Next
.
10. At the Registration screen, select
Register
and follow the on-screen instructions or
select
Register Later
and click
Next
.
11. Click on
Finish
to complete the installation.
B) Drivers and Programming Software For Advanced Users
1. Follow points 1 – 8 of the install procedure in A), then at the Programming Software
screen, select
Advanced User
and click
Next
.
2. At the
Programmable Controller Drivers
screen, click
Update
and follow the on-screen
instructions.
3. Then at the
Installation of programming software successful
screen, click
Next
.
4. At the
Registration
screen, select
Register
and follow the on-screen instructions or
select
Register Later
and click
Next
.
5. Upon completion of the installation, you have the option to
Run Profile Editor
, which will
give you a view of the 3D programming environment. If you do not wish to see the Profile