User Manual

At this point we recommend that you select the No, not this time option and then click
on Next to carry on with the installation.
A) Drivers Only For Typical Users
1. With your computer switched on, close down any programs that are currently running
and insert the Saitek Smart Technology CD into your CD-ROM drive.
2. When the Introduction Screen appears, click
Install Software
to continue. If the CD does
not run automatically, select
Start
from the Windows® Taskbar, then
Run
and type
D:\Setup.exe
and click OK - where D:\ is letter of your CD-ROM drive.
3. When the Welcome screen appears, click
Next
to continue.
4. After reading the Disclaimer, select the
I accept the terms of the Disclaimer
option and
click Next to continue.
5. At the Driver Setup screen, if you haven’t already done so, plug the USB cable of your
docking station into one of your computer’s USB ports and click on
Next
.
6. At the Driver Setup screen, click
Next
to test your controller.
7. When the Saitek Controller screen appears, try out all your controller’s buttons and
controls to show that it is working properly. When you have finished, click
OK
.
8. At the Software Setup screen, select
Do not install the SST Programming Software
and click
Next
. The Programming Software can be installed at a later date by following
instruction (B). below
9. At the Registration screen, select
Check this box to register now
and follow the on-
screen instructions, or you can choose to select this option later.
10. Click on
Finish
to complete the installation.
B) Drivers and Programming Software For Advanced Users
Follow points 1 – 7 of the install procedure in A), then at the Software Setup screen, select