Technical information

Installation
Doc. 065186-02 1/12 11
2. Connect the Dionex VP connector plug to the 12-position connector
plug. Refer to the table below for pin connections.
To attach a wire to the 12-position connector plug, insert it into the
plug, and use a screwdriver to tighten the locking screws.
3. Plug the 12-position connector plug into the TTL and relay connector
on the Dionex ICS-1000/1500/2000 rear panel.
Go on to Section 5.2
to set up Chromeleon.
When attaching wires to the connector plug, be careful not to allow
stray strands of wire to short to the adjoining position on the
connector.
Connect this Dionex VP
pin:
To this position on the connector plug:
Pin 1 Position 3
Pin 2 Position 4