Technical information

Dionex VP Vacuum Pump Installation
10 Doc. 065186-02 1/12
2. Connect the Dionex VP connector plug to the 25-position connector
plug. Refer to the table below for pin connections.
To attach a wire to the 25-position connector plug, insert it into the
plug, and use a screwdriver to tighten the locking screw. Repeat for
the second position.
3. Replace the cover on the 25-position connector plug. Plug the
connector into the digital I/O port on the Dionex DP/SP rear panel.
Go on to Section 5.2
to set up Chromeleon.
Connecting the Dionex VP to a Dionex ICS-1000/1500/2000
1. Locate the 12-position
connector plug
(P/N 923686) in the
Dionex ICS-1000/1500/
2000 Ship Kit (see
Figure 6
).
Figure 6. 12-Position Connector Plug
When attaching wires to the connector plug, be careful not to allow
stray strands of wire to short to the adjoining position on the
connector.
Connections for One Dionex VP to a Dionex DP/SP
Connect this Dionex VP
pin:
To this position on the connector plug:
Pin 1 Position 20
Pin 2 Position 8
Connections for a Second Dionex VP to a Dionex DP
Connect this Dionex VP
pin:
To this position on the connector plug:
Pin 1 Position 14
Pin 2 Position 15
Position 1
Locking
Screws
Position 12