Operating instructions

17
6 Maintenance and servicing
To ensure a long-term quality from the cutting with the CST, please follow the maintenance plan
below:
Begin of the day During the changing of tool End of the day or more often if required Every week After a fault After a damage
Visual control (general aspect,
watertightness)
Whole machine
Clean
Flange and blade fixing devices Clean
Motor cooling fans Clean
Water pump Clean
Water pan Clean
Cutting table Clean
Water hoses and nozzles Clean
Water pump filter Clean
Cart guiding bars Clean
Motor housing Clean
Reachable nuts and screws Tighten up
Maintenance of the motor
Always perform the maintenance of the motor with the machine isolated from the electrical supply.
Cleaning of the machine
Your machine will last longer if you clean it thoroughly after each day of work, especially water
pump, water pan, cutting head axles, motor and blade flange.
Never use acid-based cleaning products, as the aluminium parts (water tray, axles, motor housing,
frame) can be corroded by these cleaning products. Always clean the machine when any cutting
dust and debris is still fresh, never allow the deposits to solidify.
Lubrication
The CST uses life-lubricated bearings. Therefore, you don’t need to lubricate the machine at all.