User manual

Chapter 2: Operation
Setup 19
22222
Operation
Setup
The following setup pages are described in this section of the manual:
• Radio setup
• Channel setup
• Power Supply
• System setup
• Controller setup
Accessing a setup page
To change a setting in one of the SETUP pages, do as follows
1. Press the soft key SETUP.
2. Press the arrow soft key or to advance to SETUP page you want
to edit.
3. Turn the selector knob to go to a setting, then press the selector knob to
change the setting.
4. Press EXIT to return to normal radio operation.
Radio setup
Parameter Description
Scan Hang
Time
Scan hang time, in seconds on an active receiving working
channel. The time is measured from the signal is detected. The
radio remains on the channel for the set time interval, if a signal
was detected.
OFF: Resumes scanning when signal disappears (default)
4, 6, 8, 10: Hang time in seconds.