Installation manual

Chapter 3: Installation
62 System setup
Ground stud
To ground the radio connect a ground wire
from the ground stud of the radio to a
suitable grounding point. Use an
appropriately sized wire. The ground stud is
located above the VHF antenna connector.
System setup
To change a setting in the SYSTEM SETUP, do as follows:
1. Press the soft key SETUP. If it is not in the display, press the soft key MORE
until SETUP appears.
2. Press the arrow soft key or to advance to SYSTEM SETUP.
3. Turn the selector wheel knob to go to a setting, then press
the selector wheel knob to change the setting.
4. Press EXIT to return to normal radio operation
.
SYSTEM SETUP Description
NMEA input (baud rate) 4800 (default) or 38400
Factory Defaults Resets the radio to factory defaults
System time & Date View and set system time and date
SW version Software version of the radio
S/N Serial number of the radio