User Manual

FCC ID: 2AVYX-TMSS6A4

FCC statement

This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to Part 15 of the FCC Rules.

These limits are designed to provide

reasonable

protection against harmful

interference in a residential installation. This

equipment generates, uses and can

radiate radio frequency energy and, if not installed and

used in accordance with

the instructions, may cause harmful interference to radio

communications.

However, there is no guarantee that interference will not occur in a particular

installation.

If this equipment does cause harmful interference to radio or television

reception,

which can be determined by turning the equipment off and on, the

user is encouraged to

try to correct the interference by one or more of the

following measures:

—

Reorient or relocate the receiving antenna.

—

Increase the separation between the equipment and

receiver.

—

Connect the equipment into an outlet on a circuit

different from that to which

the

receiver is connected.

—

Consult the dealer or an experienced radio/TV technician for help.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two

conditions: (1)

This

device may not cause harmful interference, and (2) this device must accept

any interference received, including interference that may cause undesired operation.

CAUTION: Any changes or modifications not expressly approved by the grantee of this device

could void the user's authority to operate the equipment.

5.1 It is not allowed to install the sensor on the unapproved rim

;

Cautions:

2 Do not repeatedly install or disassemble the sensor;

3 Make sure that the rim is properly installed with sensors in good condition;

4 It is forbidden to damage the sensor during the whole installation and disassembly process;