User Manual

11
S6.6 Sensor installation
Instructions for installing the sensor: 1. Hold the
sensor, pass the valve through the rim hole, and pre-tighten the nut; (Picture 1) 2. Repeat step 1, pre-tighten 5pcs-6pcs rim (one layer
of the pallet); 3. Hold the wrench with the left hand to clamp Hold the valve chassis or deflect it slightly to
the right and stabilize it, and tighten the nut with an electric or manual torque wrench in your right hand. (Picture 2) Installation inspection: After installation, the sensor is in a positive parallel state with the arc of the rim, and the surface of the cover plate
is not in contact with the arc of the rim. Then the installation is complete.
Remarks: For the detailed installation process, see the product installation instruction manual
Picture 1
Picture 2