Machine Translated by Google S6.
TPMS system solution TPMS system description Tire pressure monitoring system: It can monitor the tire pressure and temperature in real time, give an alarm for abnormal tire pressure and temperature, and remind users to keep Maintain reasonable tire pressure (including sensor, controller) The sensor is installed in the car tire to detect the pressure and temperature of the car tire; the controller is installed in the car body to receive the transmitted signal.
01 Table of contents S6.6 Product structure 02 S6.6 Performance parameters 03 S6.
01 S6.
Machine Translated by Google 3D structure display
Machine Translated by Google Sensor structure design Describe the S6.6 structure illustrate 1. The battery is parallel to the PCB, and the overall appearance of the S6.6 structure is relatively wider and Exterior thinner; 2. The edge of the S6.6 structure shell is rounded, and the rib design is optimized to ensure the overall strength of the shell. At the same time, it reduces the risk of the shell being scratched by the bead during tire loading; 1.
Machine Translated by Google 02 S6.
Fundamentals of chip work Sensor Pressure Temperature Transmitter Sensor Preprocessing Radial Acceleration Tangential Acceleration Power 8
S6.6 Performance parameters serial number 1 2 3 4 5 6 7 8 9 10 project S6.6 Structure Pressure range (kPa) Working temperature (℃) Working voltage (V) RF frequency range (MHz) RF baud rate(bps) Frequency deviation (kHz) Power (dbm) RF center frequency (MHz) Quiescent current (μA) RF transmit current (mA) 0~800 Remark relative pressure -40~+125 3 433.05 - 434.79 9600 ±45 -1.78 ERP 433.92 0.1~1.0 1.0~9.
03 S6.
S6.6 Sensor installation Instructions for installing the sensor: 1. Hold the sensor, pass the valve through the rim hole, and pre-tighten the nut; (Picture 1) 2. Repeat step 1, pre-tighten 5pcs-6pcs rim (one layer of the pallet); 3. Hold the wrench with the left hand to clamp Hold the valve chassis or deflect it slightly to the right and stabilize it, and tighten the nut with an electric or manual torque wrench in your right hand.
Cautions: 5.1 It is not allowed to install the sensor on the unapproved rim; 5.2 Do not repeatedly install or disassemble the sensor; 5.3 Make sure that the rim is properly installed with sensors in good condition; 5.4 It is forbidden to damage the sensor during the whole installation and disassembly process; FCC ID: 2AVYX-TMSS6A4 FCC statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
RF exposure warning This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment must be installed and operated in accordance with provided instructions and the antenna(s) used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter.
