User Manual

19
5. - SETUP
5.1 – MENU
Addr
001 - 512
DMX address setting
Chnd
16Ch / 30Ch
Channel mode
SLnd
Auto
Auto mode
Soun
Sound mode
SL 1
Slave mode 1
SL 2
Slave mode 2 (SLAVE with PAN/TILT inverted)
ID
00 - 15
ID address
SHnd
SH-0 / SH-1 / SH-2 / SH-3
4 different built-in shows
SEns
000 - 100
Microphone sensitivity
bLnd
bLAc
Without DMX the projector goes in zero position
Auto
Without DMX the projector goes in Auto mode
Soun
Without DMX the projector goes in Sound mode
Hold
Without DMX the projector remains in last position
LED
On / Off
On = display always on
Off = display off after 5 seconds
diSP
yes / no
Yes = display in right position
No = display in inverted position
rPAn
no / yes
No = pan not inverted
Yes = pan inverted
rtIL
no / yes
No = tilt not inverted
Yes = tilt inverted
rSEt
yes / on
Reset
5.2 – MASTER/SLAVE MODE
In this mode, more units can be linked together as a single chain and work in a synchronized
way.
• Use a DMX cable to link together all the units from the connector DMX OUT to DMX IN.
• Define the first unit of the chain as MASTER, all other units must be set in SLAVE1 mode
(SL1) or SLAVE2 (SL2).
• Operate the Master unit in Automatic mode (Auto) or Sound (Soun) to operate the entire
system. The entire chain of Slave unit will act as the Master unit.