User Manual

ManualsBrandsSagitter ManualsLightsLED Kit 3 Bat - KIT 4 LED PROJECTORS 3X6W RGBW / Full Color

MANUAL LEDS LED 1 … LED 4

Red (000 – 255)

Manual Red dimmer setting for each LED

Green (000 – 255)

Manual Green dimmer setting for each LED

Blue (000 – 255)

Manual Blue dimmer setting for each LED

White (000 – 255)

Manual White setting for each LED

RESET

Reset

(*) the function Wireless Release is used to unlink the wireless of the projector to the

wireless of the footswitch:

- Enter in the menu SETUP – Wireless release

- Press ENTER

- Press and hold UP or DOWN button. After few seconds it will appears the writing

“Initialization” and after the writing “Release Finish”. Release the button, now the projector

and the footswitch are unlinked.

- To link again the projector to the footswitch, switch ON the projector, switch ON the

footswitch, press the red button under the footswitch for few seconds. After few time the

projector will be linked again to the footswitch.

WARNING: it is possible to link one footswitch to different projector. The maximum number

of projector to connect is 6 pcs. If more projectors will be linked, it is possible that some

projectors block. In this case, in order to unlock, switch OFF and after switch ON the blocked

projector.

6.2 – MASTER/SLAVE MODE

In this mode, more units can be linked together as a single chain and work in a synchronized

way.

· Use a DMX cable to link together all the units from the connector DMX OUT to DMX IN.

· Define the first unit of the chain as MASTER, all other units must be set in SLAVE mode.

· Operate from display the Master unit in Automatic mode (AUTO) or Sound Mode (SOUND)

to operate the entire system. The entire chain of Slave unit will act as the Master unit.

· WARNING: if it is necessary to use the footswitch in order to set AUTO or SOUND,

all the slave units have to be set with the Wireless OFF, by using the command

“Wireless STA = OFF”.

3. - APERTURA DELLA CONFEZIONE E CONTROLLO

Aprire con cura la confezione, verificare il contenuto e assicurarsi che tutte le parti siano

presenti e siano in buone condizioni. Nel caso in cui alcune parti non siano presenti o siano

danneggiate, contattare immediatamente il proprio fornitore e conservare l’imballaggio per la

verifica.

ATTENZIONE!

Se l'apparecchio è stato esposto a drastici sbalzi di temperatura,

lasciare spenta l'unità finché non raggiunge la temperatura ambiente.

La presenza di condensa potrebbe danneggiare il prodotto se acceso.

Controllare che la scatola contenga i seguenti articoli:

N° 1 SG LEDKITHP3BAT (batterie incluse)

N° 1 Stativo di supporto

N° 1 Cavo di alimentazione

N° 1 Pedaliera wireless + antenna rimovibile (batterie tipo AA non incluse)

N° 1 Manuale Utente

N° 1 Borsa morbida

N° 2 Staffe supporto + manopole

VISTA ANTERIORE

1 – Lenti

VISTA POSTERIORE

1 – Interruttore ON/OFF

2 – Antenna

3 – Display

4 – Power IN/OUT

5 – DMX in/OUT