User Manual

27
2. Press "ENTER" button, and "SPEED“ or "AUTO MODE" will be showed. Then press ENTER,
and you can see two items as below:
- AUTO SPEED - You can select your desired speed in this menu.
- AUTO MODE - You can select your desired auto mode in this menu.
CUSTOMER
In this menu you can select your desire CUSTOMER mode.
1. Press "ENTER" button and then UP or DOWN button untiI "CUSTOMER" is showed.
2. Press "ENTER" and you can select the effect created in the menu "EDIT EFFECT" (see
below).
STAT COLOR
In this menu you can adjust the value of static color and strobe speed as you like.
1. Press "ENTER" button and then UP or DOWN button until "STAT COLOR" is showed.
2. Press "ENTER" button, and there are five options. Then press "ENTER" to select the option
and press UP or DOWN button to select the value you desire as below:
- STAT RED - You can adjust the red brightness in this menu.
- STAT GREEN - You can adjust the green brightness in this menu.
- STAT BLUE - You can adjust the blue brightness in this menu.
- SELET COLOR -You can select 51 static color in this menu.
- STAT STROB - You can adjust the strobe speed in this menu.
EDIT EFFECT
In this menu, you can edit your desired AUTO program.
1. Press "ENTER" button and then UP or DOWN button until "EDIT" is showed.
2. Press "ENTER" button, and open the "EDIT“ mode to edit the custom programs
from“PR.01" to“PR.11".And there are 32 scenes that can be edited in each custom
program.
3. You can edit a scene by adjusting the value of "RED (000-255)","GREEN (000-255)", "BLUE
(000-255)", "FADE (000-031)", "FLASH (000-050)", "STROBE (000-031)" and "TIME (000-
000)" as you like. Then the data will be saved, when you press the ENTER button for 15
seconds.
Attention: When you set the mode, the led modes must set the same.
UPLOAD
In this menu, you can set the control box for the same mode when using more than one box
connected in DMX. Other will follow the same mode (it is for the control box).
1. In the Box that have to send the data, press the MENU button and UP button or DOWN
button until "UPLOAD" is showed, then press ENTER.
2. Press the ENTER button to set the same mode for the control box.
LOAD SETTIN
This function is used to send to the bars all the settings of the control box (DMX address,
Channels mode, SAME or DIFFERENT mode, AUTO modes etc.). This function have to be
used when one or more of these setting are changed in the box.
1. Press the MENU button and UP and DOWN button until "LOAD SETTIN" is showed, then
press ENTER
2. The blue leds will flash and after 10 seconds the display shows "Ack data ok". It means
successful setting. Otherwise it will shows "Wait Ack data", please check the setting
and repeat the steps above, until it shows "Ack data ok".
RESET
In this menu, you can reset all the values of the system to the default.
1. Press "ENTER" button and then UP or DOWN button until "RESET" is showed.
2. Press the ENTER button to reset all the values of the system to the default.