User Manual

26
DMX
In this menu, you can connect several boxes with DMX cable and control with control console.
1. Press "ENTER" button and then UP or DOWN button until “DMX" is showed.
2. Press "ENTER" button, and “CHANNEL", “Box ADDRESS", “Led Modes" , "Light Number" or
"Light ADDRESS" will be showed. Then press ENTER.
- "ChanneI xxx" will be showed, "xxx" represents the showed DMX channel mode. You
can press the UP or DOWN button to select your desired Channel mode.
- "Box ADDRESS xxx" will be showed, "xxx" represents the start address of the box. You
can press the UP or DOWN button to select your desired address. See page 31 for
detailed explanation.
- "Led Modes Different" or “Led Modes Same" will be showed.
- Same - The lights will be showed in the same effect.
- Different - The lights will be showed in the different effects in sequence.
- "Light Number xxx" will be showed, press the UP or DOWN button. You can know the
number of connection lights.
- "Light Address xxx" will be showed, "xxx" represents the showed DMX light address.
You can press the UP or DOWN button to select your desired DMX light address. This
address is useful if you will use the lights without box. See page 31 for detailed
explanation.
RUN MODE
In this menu, you can select DMX mode or SLAVE mode (Master / Slave). In SLAVE mode, you
can select one box as the MASTER light and other lights in SLAVE mode will run following the
MASTER light.
1. Press “ENTER" button and then UP or DOWN button until “RUN MODE" is showed.
2. Press “ENTER" button, and "DMX" or “SLAVE" will be showed, thenpress ENTER to select
your desired mode.
SET UP
In this menu, you can adjust the value of the function.
1. Press "ENTER" button and then UP or DOWN button until “SET UP" is showed.
2. Press "ENTER" button, and then UP or DOWN button to select the value you desire as
below.
- Display Led - In this item. you can select "ON" or “OFF". If you select ON, the
displayer will be on all the time. And if you select OFF, the displayer will extinguish
about ten seconds later.
- Key locks - You can select whether the password is on or off in this menu, and the
password is [DOWN]+[UP]+[DOWN]+[UP]. If you select “ON", you have to input the
password before pressing the buttons. Otherwise the light won’t respond.
INFORMATION
In this menu, you can learn about the information of software, hardware and the working
time of the light.
1. Press “ENTER" button and then UP or DOWN button untiI "INFORMATION" is showed.
2. Press “ENTER" button, and “Software" "Hardware" "Fix times" or "Pcb temp" will be
showed. Then press ENTER, and you can see three items as below;
- Software - This item displays the Software information.
- Hardware - This item displays the Hardware information.
- Fix times - This item displays the working hours about the light.
- Pcb temp - This item displays the temperature about the light.
AUTO
In this menu, you can select your desire AUTO mode and adjust the running speed.
1. Press "ENTER" button and then UP or DOWN button untiI "AUTO“ is showed.