User Manual

22
3. - OPENING AND CONTROL
Carefully open the package, check the content and make sure that all the parts are present
and are in good condition. In cases where some parts are not present or are damaged,
immediately contact Your supplier and retain the packaging for verification.
WARNING!
If the product has been exposed to drastic temperature changes, let
the unit turned off until it reaches room temperature because the
presence of condensation can damage the product if it is turned on.
Verify that the box contains the following items:
N° 1 SG IPLEDMCBAR54RGB
N° 1 Adapter cable input
N° 1 Output IP65 connector with rubber cover cap
N° 1 Remote controller
N° 1 User Manual
FRONT VIEW
1 – Lenses
REAR VIEW
1 – Input
2 – Output
1
1
2
IP65 CONNECTOR
1 - rubber cover cap
This connector have to be removed only If more bars are
connected in a chain. In this case the IP65 connector with
rubber cap installed in the output of each bar, can be
removed in order to connect each bar to the next bar in the
chain. In the last bar of the chain DON'T REMOVE the IP65
connector with the rubber cap, in order to guarantee the
IP65 protection degree.
The rubber cap in this connector have to be removed ONLY
if the connector have to be used to create an extension
cable or an adapter, see previous diagram.
1