User Manual

20
IP65 PROTECTION RATING
The device is protected against the dust penetration (first digit 6) and against jets of water
(second digit 5). Suitable for outdoor use.
WARNING!
If more bars are connected in a chain, the IP65 output of each bar have to be directly
connected to the IP65 input of the next bar. In this case the IP65 connector with the
rubber cap installed in the output of each bar can be removed in order to connect each
bar to the next bar in the chain. In the last bar of the chain DON'T REMOVE the IP65
connector with the rubber cap, in order to guarantee the IP65 protection degree.
The rubber cap in this connector have to be removed ONLY if the connector have to be
used to create an extension cable or an adapter, by following the next diagram for
connection:
For extension cables it is possible also to use specific Sagitter extension cables
SG IPCPLU3 (mt.3) - SG IPCPLU5 (mt.5) - SG IPCPLU10 (mt.10) sold separately.
PROTECTION AGAIN ELECTRIC SHOCK
The device must be connected to a power supply system with efficient earthing. Moreover, it
is recommended to protect power supply lines of the product from indirect contact and / or
shorting to earth by using appropriately sized anti electrical shock switch.
CONNECTION TO THE MAINS
The electrical connection must be carried out by a qualified electrician.
Ensure that the mains frequency and voltage correspond to those for which the equipment is
designed, as shown in the electrical data label. This label also shows the power consumption
that is necessary to refer to evaluate the maximum number of devices to be connected to
the electricity line, in order to avoid power overloading.
If the external power cord of this light is damaged, it must be replaced with a special cord
exclusively available from Your PROEL dealer.
Never operate the equipment with lenses and / or covers missing or damaged.
In case of non-use, it is recommended to unplug the projector from the mains.
L
N
DMX pole 1
DMX pole 2
DMX pole 3