User Manual

18
5. - SETUP
5.1 – MENU
DMX ADDRESS
001 - 512
DMX address
CHANNELS MODE
3CH / 5CH / 8CH / 13CH
DMX channels mode
DIM CURVE
CURV 1 - 4
Dimmer curve setting
DMX STATE
DMX HOLD / BLACKOUT
Status if DMX is lost
SLAVE MODE
SLAVE
Slave mode
AUTO MODE
SPEED
01 – 31
Manual settings of automatic modes
(memorized even if the projector is OFF)
AUTO
01 – 10
MANUAL MODE
RED
000 – 255
Manual settings of RGB colors
(memorized even if the projector is OFF)
GREEN
BLUE
STROBE
000 – 020
Built-in macro colors
(not memorized if the projector is OFF
COLOR
001 – 055
SETUP
DIMMER ALL
000 – 255
Max dimmer limit setting
BALANCE
RED (000 – 255)
White balance
GREEN (000 – 255)
BLUE (000 – 255)
KEY LOCKS
ON / OFF
Display lock
PWD: DOWN+UP+DOWN+UP
REMOTE
ON / OFF
Remote controller ON/OFF
DISPLAY
30s / ON
Backlight display timing
RESET
REFRESH RATE
600HZ / 1200HZ / 2400HZ
/ 4800HZ
LEDs Refresh rate setting
MAX TEMP
30 – 70 °C
Max temperature setting. After this limit
the light of the LEDs is reduced.
INFO
SOFTWARE VER
Software version
WORKING TIME
Working time
RDM: UID
ID RDM
5.2 – MASTER/SLAVE MODE
In this mode, more units can be linked together as a single chain and work in a synchronized
way.
• Link together all the units from the connector DMX OUT to DMX IN.
• Define the first unit of the chain as MASTER, all other units must be set in SLAVE mode.
• Operate the Master unit in Automatic mode or Static mode to operate the entire system.
The entire chain of Slave unit will act as the Master unit