User Manual

21
5. - SETUP
5.1 – MENU
DMX MODE: zz CH
ADDR: xxx-yyy
zz = channel modes (3, 4, 6, 8, 10, 16, 20)
xxx = start DMX address
yyy = last DMX channel used
Press ENTER and UP/DOWN to
set the DMX address
CHANNEL MODE
zz CH
Set the DMX channel modes (3, 4, 6, 8, 10,
16, 20 channels)
Press ENTER and UP/DOWN to
set the DMX channel mode
SLAVE
MODE
Slave mode
Press ENTER to set Slave mode
AUTO RUN
SP:xx REP:yy
Built-in auto program
SP: program speed
REP: repeat
Press ENTER and UP/DOWN to
set the program speed and the
repeat
EFFECT MODE
SP:xx F:yy
Built-in selectable effects
SP: effect speed
F: strobe
Press ENTER and UP/DOWN to
select the effect and set speed
and strobe
FLOW INVERT
ON/OFF
Reverse flow effect
OFF = standard flow
ON = reversed flow
Press ENTER and UP/DOWN to
select this mode
STATIC COLOR
Fixed colors:
COLOR WW
COLOR CW
RED
ORANGE
YELLOW
GREEN
CYAN
BLUE
PURPLE
COLOR SET – RED (000 – 255)
COLOR SET – GREEN (000 – 255)
COLOR SET – BLUE (000 – 255)
COLOR SET – WHITE (000 – 255)
Press ENTER and UP/DOWN to
select one of fixed colors or to
manually adjust one of them.
MASTER DIM
<xxx> (yyy%)
Max limit of master dimmer
xxx = (000 – 255) selectable
yyy = percentage value of xxx,
automatically showed
Press ENTER and UP/DOWN to
set the maximum limit. Default:
255.
SET WHITE BAL
White balance for each led block:
PIXEL: (001 – 004): selectable led block
R: (000 – 255): manual red adjusting
G: (000 – 255): manual green adjusting
B: (000 – 255): manual blue adjusting
W: (000 – 255): manual white adjusting
Press ENTER and UP/DOWN to
select the block of led and the
values of each color.
DIMMER CURVE
LINEAR / SQUARE / INV. SQUARE / S-
CURVE
Press ENTER and UP/DOWN to
select the specific dimmer
curve. Default: SQUARE
LOCKING
ON/OFF
Automatic display lock
OFF = display not locked
ON = display locked (to unlock press the
sequence UP-DOWN-UP-DOWN-ENTER)
Press ENTER and UP/DOWN to
set this mode