User Manual

11
3. - OPENING AND CONTROL
Carefully open the package, check the content and make sure that all the parts are present
and are in good condition. In cases where some parts are not present or are damaged,
immediately contact Your supplier and retain the packaging for verification.
WARNING!
If the product has been exposed to drastic temperature changes, let
the unit turned off until it reaches room temperature because the
presence of condensation can damage the product if it is turned on.
Verify that the box contains the following items:
N° 1 SG AIRBOX
N° 1 Power Adapter
N° 1 User manual
4. - CONNECTION IN A DMX CHAIN
SG AIRBOX can be used to transmit via wireless the DMX signal to the products that support
the Wireless protocol.
WIRELESS CONNECTION
- Connect the SG AIRBOX to the DMX console and set it up as transmitter (TX) by pressing
down the green button.
- In the projector enter in the menu WIRELESS and select ON, press ENTER.
- All the projectors have to be linked to the transmitter, by following the next steps:
1. After the projector is switched on, and if there are no new transmitter, the projector
will connect to the old transmitter automatically.
2. If the projector has to be linked to a new transmitter, it needs to clear the old wireless
settings:
a. Enter in RELESE menu, press and hold + or - for 10 seconds.
b. When the wireless status indicator LED switches OFF, the projector is unlinked.
3. To link the projector to a new transmitter, follow the next steps:
a. Press and release PAIRING button on the transmitter.
b. The LED wireless status on the projectors will start to fast flashing and then stay
on. Pair success.
It is possible to remove at the same time, the wireless link between a group of projectors and
their transmitter: press and hold for about 5 seconds the PAIRING button on the transmitter
and release when the relative status led blinks. The wireless link in all the projectors will be
removed (Wireless statue LED indicator off).