User Manual

24
AUTO MODE
- To select the Auto Mode, press AUTO/DEL button until Auto led is lit
- Switch off all buttons SCANNERS 112
- If no CHASE buttons are pressed, it will run bank automatically. Select the desired bank
via BANK UP/DOWN buttons.
- Press a CHASE button, it will run the case automatically. You may press more then one
chase to run them one by one.
- You may adjust the interval time between steps via SPEED fader , and adjust the duration
time via FADE TIME fader
- In auto mode, you can control each projector in manual mode. Press the respective
SCANNERS button and move the sliders.
MIDI OPERATION
- Press and hold the MIDI/REC button for three seconds.
- Use the BANK UP/DOWN to select the DMX channel 01-16 to assign to MIDI channel
- Press and hold down the MIDI/REC for three seconds to store your setting and to
deactivate MIDI setting.
- If you wish to give up your setting, tap any other button except BANK UP/DOWN to ext
MIDI mode
- This unit receives Note On signals which enables to run 15 banks (01-15) of scenes, and
6 chases of scenes. In addition, black-out function can be activated by MIDI signal.
Bank: Note number: Function:
Chase
Bank 01 00 to 07 turn On or Off scenes 1-8 of bank 1
Bank 02 08 to 15 turn On or Off scenes 1-8 of bank 2
Bank 03 16 to 23 turn On or Off scenes 1-8 of bank 3
……… ……………. ……………….
Bank 13 96 to 103 turn On or Off scenes 1-8 of bank 13
Bank 14 104 to 111 turn On or Off scenes 1-8 of bank 14
Bank 15 112 to 119 turn On or Off scenes 1-8 of bank 15
Chase 1 120 turn On or Off chase 1
Chase 2 121 turn On or Off chase 2
Chase 3 122 turn On or Off chase 3
Chase 4 123 turn On or Off chase 4
Chase 5 124 turn On or Off chase 5
Chase 6 125 turn On or Off chase 6
126 black-out
5. - MAINTENANCE
To ensure optimal performance, the unit must be frequently cleaned. Unplug the device
from the mains. Use a vacuum cleaner or an air compressor and a soft brush to remove the
dust deposited.
Any damaged part, must be replaced with original spare parts.