User Manual

20
OPERATION
MANUAL MODE
To select the manual mode, press AUTO/DEL button, until manual led is lit.
In manual mode (program led off), you can call up the connected scanners manually, and
control them via the channel faders. Please note that adjusted settings cannot be
memorized.
Select the respective scanner via the respective SCANNER button. Adjust the desired function
via the channels faders.
CHECK A BANK/SCENE
Select the bank you want to check via BANK UP/DOWN buttons. Select the scene you want to
check via one of the SCENE button.
CHECK A CHASE:
Select the chaser you want to check via the CHASE button. Press DISPLAY button, the
display will show the step in the chase. Press BANK UP/DOWN buttons to see each
scene.
Via the PAGE SELECT, button, you can adjust the channel faders from Ch.1 to Ch.8 (page A,
led lit) to Ch.09 to Ch.16 (page B, led lit) or both of them (page A and B, led lit together).
Via the DISPLAY button, you can switch the display of the faderway from DMX value (0 – 255)
to percent (0 – 100%).
PROGRAMMING
A program (bank) is a sequence of different scenes (steps) that will be called up one after
another. With this DMX operator, you can program up to 30 different programs (banks) with
up to 8 scenes (steps) each.
PROGRAMMING A PROGRAM:
- Press and hold the PROGRAM button for about 2 seconds to enter the programming
mode. The program flash will flash.
- Select the desired program (bank 01 – 30) you will save via the BANK UP/DOWN button.
- Select the desired scanner via the SCANNER select button.
- Adjust the desired settings (the value will be shown in the display) via the respective
channel faders.
- Press MIDI/REC button to prepare saving.
- Press one of the SCENE buttons in order to save the data. All leds on the panel will be
flashing, indicating the data is saved.
- Repeat the steps above, until the program is finished of the maximum number of steps
(8) has been reached.
- Press and hold the PROGRAM button in order to exit programming mode.
RUNNING A PROGRAM:
- Press the BANK UP/DOWN buttons and select the desired program.
- Press the AUTO button, the Auto led will be lit.
- Adjust the program speed via the SPEED fader and the repetition rate via the FADE TIME
fader.
- As an alternative, you can adjust the program speed by tapping the DISPLAY button
twice. The time interval between the two taps, corresponds to the program speed (up to
10 minutes).