User manual

Chapter 5 Management Page 54
Click “Open”, a window as below will popup:
Figure 37 SSH
Enter the user name and password (Default user name/ password: admin/password) respectively,
you will see “DEVICE123456>”, which is the name of SGT-LD-55-23;
Enter “help” command to get setting information; alternatively, you can refer to Appendix C. SSH
Settings for details.
SNMP
The SGT-LD-55-23 supports SNMP management. Set the SNMP parameters and obtain MIB file before
remote management.
From “Remote Management” in “Management”, set the parameters for SNMP:
- Enable SNMP by checking “Enable”;
- Specify the “Read Community Name”, “Write Community Name” and “IP Address to Receive
Traps”
- Hit “Apply” to save settings.
Obtain the MIB file via FTP:
- Enter ftp 192.168.1.1 , username (Default: admin) and password (Default: password);
- After successful login, enter command “get bridge.mib”, the information will as below and then
bridge.mib file is obtained.