User manual

Chapter 4 Advanced Settings Page 41
Super Mode
Available in Bridge (CSMA), Base Station and CPE mode, Super Mode is an effective way to enhance
throughput performance. It can boost the transmission data rate up to 108Mbps. To enable Super Mode,
the remote terminal should also have the function enabled. Note that this function should only be
activated if all of the wireless devices share the same wireless connectivity (i.e. all must support Super
mode). (The throughput may vary depending on the actually environment and data traffic flow).
Open “Radio” in “Wireless”, Super Mode is as below:
Figure 25 Super Mode
Note that this function should only be activated if all of the wireless devices share the same
wireless connectivity.
The throughput may vary depending on the actually environment and data traffic flow.
Note: