User manual

Chapter 3 Basic Settings Page 32
can avoid packet collisions and send the packets much more efficiently allowing for higher effective
throughput rates. This function is only available in CSMA BS mode (RF2). It is highly
recommended to enable TDM coordination when there are multiple CPEs needing to connect to the
BS in your application.
NoACK
Under TDMA mode, enabling NoACK can enhance throughput but it might result in higher error rates
in a noisy environment.
WMM
WMM (Wi-Fi Multimedia) is a subset of 802.11e. It allows wireless communication to define a
priority limit on the basis of data type, thus time-sensitive data, like video/audio data, may have a
higher priority than a common data type. To enable WMM, the wireless client should also support
it.
Super Mode
Super mode is an effective way to enhance performance. It can boost the transmission data rate
up to 108Mbps. To enable Super Mode, the remote SGT-LD-55-23 should also have this function
enabled. For more information you may refer to Super Mode in Chapter 4 Advance Settings.