User manual

Chapter 3 Basic Settings Page 28
Basic System Setup
For users who use the SGT-LD-55-23 for the first time, it is recommended that you begin configuration
from “Basic” in “System” shown below:
Figure 17 Basic Setup
Wireless Device Name
Specify the device name, which is composed of no more than 15 characters with (0-9), (A-Z), (a-z) or
(-).
Country/Region
Since the available radio bands vary from country to country, the working channels used are
different.
Ethernet Data rate
Specify the transmission rate of data.
Spanning Tree Protocol (STP)
Spanning Tree Protocol is a link management protocol for bridges which provides path redundancy
while preventing loops in a network. STP allows only one active path at a time between the bridges
but establishes the redundant link as a backup if the initial link fails.
STP Forward Delay
STP Forward Delay is the time spent in detecting and learning network tree topology state before
entering the forwarding state. Default time value is 1 sec. Select Normal if you would like to modify
the parameter (4-30 seconds).