User manual

Chapter 2 Hardware Installation Page 20
Figure 7 Vent
Connect Up
Before installing the Ethernet cable with a waterproof RJ-45 connector, it is recommended that the
Cat-5 RJ-45 coaxial cable be used for the SGT-LD-55-23 to power PoE connector.
1. To connect to the hole labelled PoE+Data, open the black cover in advance by using a coin or a
slotted screwdriver and then screw in the body of the gland and tighten.
Figure 8 Connect Up – Step 1
2. Slide the sealing nut to the RJ-45 cable from its middle breach and then insert the sealing into the
cable.
Slide the Sealing Nut from its Breach
Vent