Installation guide

Connect Up
Before installing the Ethernet cable with a waterproof RJ-45 connector, it is recommended
that the Cat-5 RJ-45 cable be used for the bridge to power injector connections.
To connect to the hole labelled PoE+Data, open the black cover in advance by using a
coin or a slotted screwdriver and then screw in the body of the gland and tighten.
Slide the sealing nut to the RJ-45 cable from its middle breach and then insert the
sealing into the cable.
Slide the Sealing Nut from its Breach
Insert the RJ-45 connector and make sure that the locking tab snaps home.
Screw the sealing onto the gland and tighten.