User manual

Chapter 5 Management Page 55
Figure 41 SSH
Enter the user name and password (Default user name/ password: admin/password)
respectively, you will see “DEVICE123456>”, which is the name of the SGT-LD-5-23;
Enter “help” command to get setting information; alternatively, you can refer to Appendix C. SSH
Settings for details.
SNMP
The SGT-LD-5-23 supports SNMP management. Set the SNMP parameters and obtain MIB file
before remote management.
From “Remote Management” in “Management”, set the parameters for SNMP:
- Enable SNMP by checking “Enable”;
- Specify the “Read Community Name”, “Write Community Name” and “IP Address to
Receive Traps”
- Hit “Apply” to save settings.
Obtain MIB file via FTP:
- Enter ftp 192.168.1.1 , username (Default: admin) and password (Default: password);