User manual

Chapter 5 Management Page 44
Access Control
The Access Control allows a STA to access a SGT-LD-5-23; thus, a further security mechanism is
provided. This function is available only under Base Station mode.
Open “Access Control” in “Wireless” as below, check “Turn Access Control On” to enable this
function.
Figure 31 Access Control
Available CPEs
This table lists the CPEs currently connecting to the SGT-LD-5-23. Check the box before each
MAC address, click “Add” to add one or more available CPE(s) into the “Trusted CPEs” and click
“Apply” to save settings.
Add New CPE Manually
Enter the MAC address of the CPE that you would like to list into the access control list, click “Add”,
then the CPE will be added into the “Trusted CPEs”.
Trusted CPEs
Check the box before one or more MAC addresses of CPEs that you would like to cancel and click
“Delete” to cancel that access control rule.