User manual

Chapter 3 Basic Settings Page 19
Hardware Installation
Assemble the Mounting Bracket
1. Place the main bracket into the seating and use a spanner to fasten the bracket to the
SGT-LD-5-23 with M5×16 screws ⑧ and M5 washers ⑨ provided in the hardware packets;
Figure 4 Bracket Mounting – Step 1
2. Assemble the main bracket by placing articulation pole ② to the T-form bracket ① via a
M8×90 ④ screw through the insertion axe and fix with the M8 washer ⑤ , spring washer ⑥
and M8 nut⑦;
Figure 5 Bracket Mounting – Step 2
Pole Mounting
1. Install the main bracket and the pole mount bar ③ over the top of the pole by securing the drill
holes of the pole mount bar to the main bracket ones and insert two M8×80 ④ screws, spring
washers ⑥ and washers ⑤ through the drill holes and main bracket;