Manualshelf

User manual

ManualsBrandsSagido ManualsComputer equipmentBRF70n
51525354555657585960
http://www.sapido.com.tw/ User Manual v1.0.0
59
wireless LAN security, configure the common encrypted
key (WEP Key) for access point and wireless LAN handset.
WEP key length are "64bit", "128bit", and "256bit" (This
product corresponds up to 128bit), larger the value is,
more the character can be set, and encryption strength will
enhanced.
* If you configure the encryption key as "5 letters in
half-width alphabets and numbers" or "Hexadecimal in 10
digits", please select "64-bit".
* If you configure the encryption key as "13 letters in
half-width alphabets and numbers" or "Hexadecimal in 26
digits", please select "128-bit".
WPA / WPA2 WPA/WPA2 is wireless LAN security standard which is
strengthen over WEP. On WPA-PSK/WPA2-PSK, uses
encrypted key called pre-shared key, and set up common
encryption key for access point and wireless LAN handset
like WEP. There are "AES" and "TKIP" as encryption
scheme. "TKIP" automatically updates the key at regular
intervals, check and approve the communication, so it can
communicate safer than WEP key which uses single
encryption key for long time. "AES" is harder to decode
comparing to "TKIP", so it can say tougher encryption
scheme than "TKIP"
WPA-Mixed Support WPA and WPA2 at the same time
802.1x Authentication
Radius
For radius server authentication
Personal (Pre-Shared
Key)
* If you configure Pre-Shared Key as "Hexadecimal in 64
digits", please select "Hex (64 characters) ".
* If you configure enc ryption key in "8 to 63 letters in
half-width alphabets and numbers", please select
"Passphrase
5.4.4 Access Control
Please refer Wireless Access Control
5.4.5 WPS
This page allows user to change the setting for WPS (Wi-Fi Protected Setup). Using this
feature could let your wireless client atomically synchronize it’s setting and connect to the
Access Point in a minute without any hassle. SAPIDO BRF70N could support both Self-PIN
or PBC modes, or use the WPS button (at real panel) to easy enable the WPS function.
PIN model, in which a PIN has to be taken either from a sticker label or from the web
interface of the WPS device. This PIN will then be entered in the AP or client WPS device to