User manual

MF 6990dn - Agoris C935
- 150 -
16 - Characteristics
Cards
Before starting printing cards, print out a test on standard paper to check page formatting.
Recommendations for use
Use cards for laser printers.
Do not use cards:
• Coated.
• For ink-jet printers.
• Pre-cut or perforated.
• Pre-printed or multicoloured.
Transparencies
It is possible to print continuously on transparencies, but feed problems may occur due to the media quality, the
accumulation of static electricity and the print environment.
Before starting printing transparencies, print out a test on standard paper to check page formatting.
Recommendations for use:
• Only use transparencies for laser printers.
• Regularly clean the printer paper path as transparencies are highly sensitive to dirt.
• Remove printed transparencies from the output tray to prevent the accumulation of static electricity.
• Do not fan your transparencies before loading them into the manual feeder, as this creates static electricity and may
cause printing errors.
• Avoid handling transparencies before loading them into the manual feeder as fingerprints may affect print quality.
• Do not use transparencies:
– Charged with static electricity (transparencies that stick together).
– For ink-jet printers.
Main and additional paper tray Manual feeder
Capacity Not supported Up to 20 cards depending on
thickness.
Orientation Not supported Print side facing down
Driver Card
Weight 60 to 90 g/m² (16 to 24 lb)
Duplex Not supported
Note
If the cards are warped, flatten them before
loading them into the manual feeder.
Main and additional paper tray Manual feeder
Capacity Not supported Up to 20 transparencies depending
on thickness.
Orientation Not supported Print side facing down
Driver Transparency
Weight 60 to 90 g/m² (16 to 24 lb)
Duplex Not supported