User manual

- 108 -
MF 6990dn - Agoris C935
13 - Maintenance and incidents
Packing and transporting the
machine
If you wish to transport the machine, use its original
packaging. If you do not pack the machine correctly, the
warranty may be void.
Scanner part
1 Press the On/Off button to switch off the machine
(position 0) and disconnect the mains power cable.
2 Disconnect all cables connected to the machine.
3 Close the scanner reception stop.
4 Take hold of the scanner handles and lift it to sep-
arate it from the printer part.
5 Place the scanner part in its original box with its
protective spacers.
6 Close the box using adhesive tape.
Printer part
Z If the Finisher module is installed, remove it before
starting this procedure.
Z If additional paper trays are installed, please remove
them before starting this procedure.
Z Please remove the scanner before starting this proce-
dure.
Z The machine should be switched off and all cables
disconnected.
1 Remove all toner cartridges and waste toner bot-
tles from the printer. Place the toner cartridges and
the waste toner bottle in their original box to pre-
vent possible leakage of toner.
2 Pack the printer and place it in its original box with
all the original protective spacers.
3 Place all documentation (printed documents, CD-
Rom, etc.) in the box.
4 Close the box using adhesive tape.
Firmware update
Consult our website www.sagemcom.com to know
whether there are any firmware updates available for your
machine and download the appropriate file to your PC.
It can then be installed either:
• from the integrated website;
• or using the Companion Suite Pro software.
Administrator rights
To install the update from the integrated website:
1 Go to the integrated website (see Remote
configuration [ 23]).
2 Select the SERVICES tab.
3 Select the menu TRANSFER PC.
4 In FIRMWARE UPDATE, press Browse.
5 Select the file to download and run the update.
To install the update from the Companion Suite Pro
software:
Z To update the machine firmware, the Companion
Suite Pro software must be installed on your PC,
which must be connected to the machine (see PC
Functions [ 77]).
1 Go to the update wizard (Start > All programs >
Companion Suite > Companion Suite Pro LH2 >
Companion - Firmware update).
2 Select the file to download and run the update.
Do not hesitate to consult the website www.sagemcom to
know whether new versions of this manual are available
once your software has been updated.
Note
You must have machine administrator rights
to access this function.