User manual

- 10 -
MF 6990dn - Agoris C935
2 - Installation
Installing the memory extension
To install the memory extension on the machine:
1 Press the On/Off button to switch off the machine
(position 0) and disconnect the mains power cable.
2 Disconnect all cables connected to the machine.
3 Using a screwdriver, remove the screw from the
rear cover and slide the cover to the right to remove
it.
4 Using a screwdriver, loosen the seven screws with-
out removing them completely.
5 Slide the panel slightly to the right and lift to remove
it.
6 Insert the memory extension into its connector, en-
suring it is straight, until the two locking pins click
into place.
7 Replace the panel and tighten the seven screws.
8 Replace the rear cover and fix it in place with the
screw.
9 Reconnect all cables to the machine.
> If you are installing your machine for the first time, do
not switch it on. First, complete the configuration and
connection steps described in the sections below.
> Otherwise, connect the power cable to the mains and
press the On/Off button to switch the machine on (po-
sition I).
Once the memory extension has been installed:
1 Declare the additional RAM memory in the printer
driver (Properties > Tab Configure).
2 Print out a configuration page and check that the
total RAM capacity installed is shown.
WARNING
Firstly, consult the antistatic protection in-
structions (see Antistatic protection [  9]).
Note
Locate the notch on the side of the memory
extension and align it with the connector. If
you cannot click the memory extension into
place, do not force it. Reposition it, ensuring
that its base is correctly inserted into the
connector.