Installation Instructions

Safety and Certifications
Wall Mount Installation:
This device can be mounted on a wall using the two mounting brackets on the bottom of the device,it is
recommended to use two round or pan head screws (not included)
1. Install two screws horizontally apart on a wall using the measurement shown in Figure 1. The screws should
protrude from the wall in order to fit the device between the head of the screw and the wall. If the screws are
installed in drywall. Use hollow wall anchors to ensure that the unit does not pull away from the wall due to
prolonged strain from the cable and power connectors
2. Remove the device from the product package. Connect the “F@ST 3686 V2.2 HP” to the AC Mains in accordance
with the installation instructions in this booklet, and the
markings on the identification label (voltage, current, and
frequency of electricity network).
3. Mount the device on the wall.
Refer to Figures 1 and 2 for more details.
Figure 1: Distance (horizontal) Between Brackets for Screws
Figure 2: Recommended Screw Size
Federal Communication Commission Interference Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1)This device may not cause harmful interference, and
(2)This device must accept any interference received, including interference that may cause undesired
operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation.
2