Installation guide

6-
A
dvanced parameters
Page 6-48 F@ST 2704R Reference Manual - 253526032-A
Sagemcom Broadband SAS document. Reproduction and disclosure prohibited





Field Action Default value


Enable DHCP
Check this box to activate your router's DHCP server.
Note: You must configure your computer as DHCP client and
DNS client (or enter the primary and secondary DNS
server addresses).
Checked
Start IP Address Enter the first address attributed by your router's DHCP server. 192.168.1.2
End IP Address Enter the last address attributed by your router's DHCP server. 192.168.1.254

Leased Time (hour)
Enter an unavailability time (in hours) for each attributed
address.
24

Static IP Lease List
Enter if required the list of static IP Lease.
Note: A maximum of 32 entries can be configured.
-
Configure the
second IP Address
and Subnet Mask for
LAN interface
Check the box to configure the IP parameters (IP address,
subnet mask) of a second address for the local network (LAN).
Not checked
IP Address
b
Enter a second address for your local network (LAN). -

Subnet Mask
b.
Enter a subnet mask for the second address for your local
network (LAN).
-
a. These fields only appear when the "Enable IGMP Snooping" field is activated (box checked).
b. These fields only appear when the "Configure the second IP Address and Subnet Mask for LAN interface"
field is activated (box checked).



6.4.4.1 IPv6 Autoconfig


Object: This is used to cauto-configure IP v6 protocol.

• In the Advanced Setup menu, select LAN then select IPv6 Autoconfig.
The following screen opens: