Installation guide

Page 13-2 F@ST 2704R Reference Manual - 253526032-A
Sagemcom Broadband SAS document. Reproduction and disclosure prohibited
13-
A
nnex 13 - Default configuration





This section details the values of the default parameters of your F@ST 2704R when it leaves the factory.
These default parameters can be modified by a particular preconfiguration of your F@ST 2704R.
13.1 Default username and password


Username: admin

Password: etdm (*)
(*) see information given on the router sticker


Note


The Username and Password can be different according to the ISP (Internet
Service Provider).


13.2 Default configuration for the local network(LAN)


The following table details the values of the principal LAN parameters of your router (LAN1 to LAN4):

LAN characteristics Value State
LAN1 IP address Internet and HTTP configuration tool access
(bridged)
LAN2 IP address
LAN3 IP address
LAN4 IP address
192.168.1.1/24

BROADCAST, ARP, MULTICAST _ Activated
Router _ The LAN traffic is routed to your ISP
NAT/PAT _ Activated


13.3 Default configuration for the local wireless network (WLAN)


The following table supplies the principal default WLAN parameters of your router.

Characteristics (Wi-Fi) Value
IP address 192.168.1.1/24
Enable Wireless Box checked
SSID SAGEM_3325 (*)
(*) see information given on the router
sticker
Channel Auto
Network Authentication No