Installation guide

6-
A
dvanced parameters
Page 6-104 F@ST 2704R Reference Manual - 253526032-A
Sagemcom Broadband SAS document. Reproduction and disclosure prohibited





Important

The "Key phrase" can consist of up to 15 alphanumeric characters.
To manually configure the encryption key, enter five hexadecimal pairs of digits for
each 64-bit key, or enter 13 pairs for the single 128-bit key (A hexadecimal digit is a
number or letter in the range 0-9 or A-F). Note that the WEP key protects data
transmitted between wireless nodes, but does not protect any transmissions over
your wired network (LAN) or over Internet (WAN) using Internet Explorer 5.0 or
above.

802.1x

Object: The "802.1x" standard is based on the EAP protocol (Extensible Authentication Protocol). This
enables users of the Wi-Fi network to be authenticated using a "RADIUS" authentication server
(Remote Authentication Dial-in User Service).
In this case, the WEP key is used exclusively for data encryption.

• Select the security according to the 802.1x protocol from the scroll down list; the following screen
appears:

Field Action/Meaning Default value
RADIUS Server
IP
Address
Enter the IP address of the "RADIUS" authentication server. 0.0.0.0
RADIUS Port Enter the port used for the "RADIUS" authentication server. 1812

RADIUS Key
Enter the secret key shared between the authentication server
and its clients
-
WEP Encryption This field is always active (Enabled). Enabled
Encryption
Strength
Select 64-bit or 128-bit for an encryption at 64 bits or 128 bits
respectively.
128-bit