Installation guide

6- Advanced parameters
Page 6-16 F@ST 2704R Reference Manual - 253526032-A
Sagemcom Broadband SAS document. Reproduction and disclosure prohibited





6.4 Advanced Setup


Object: This menu is used to configure the specific parameters for your router.

Important

This menu must only be used by experienced users.



This section contains the following menus:

• Layer2 Interface (see subsection 6.4.1)
• WAN Service (see subsection 6.4.2)
• 3G Config (see subsection 6.4.3)
• LAN (see subsection 6.4.4)
• NAT (see subsection 6.4.5)
• Security (see subsection 6.4.6)
• Parental Control (see subsection 6.4.7)
• Quality of Service (see subsection 6.4.8)
• Routing (see subsection 6.4.9)
• DNS (see subsection 6.4.10)
• DSL (see subsection 6.4.11)
• Upnp (see subsection 6.4.12)
• DNS Proxy (see subsection 6.4.13)
• Interface Grouping (see subsection 6.4.14)
• Certificate (see subsection 6.4.15)
• Power Management (see subsection 6.4.16)
• Multicast (see subsection 6.4.17)

Note


The menu Quality of Service only appears if you checked the "Enable Quality Of
Service" box in the WAN interface configuration screen (see Advanced
Setup>WAN Service - subsection 6.4.2>Add).