Operation Manual

CC220R

•Go to SETTINGS / SECURITY / RESTRICTION.

• Enter the base code, press OK.

• Select an empty location (dashes) or a prefix to modify, press OK.

• Enter the prefix using the keypad. Press OK.

- To activate restriction, select ACTIVATE.

- To deactivate restriction, select DEACTIVATE. Press OK.

9.5.5. MODIFYING THE BASE CODE

•Go to SETTINGS / SECURITY / CHANGE CODE.

• Enter the old base code using the keypad, press OK

• Enter the new base code using the keypad, press OK.

• Confirm by entering the new base code again, press OK.

9.6. ADVANCED SETTINGS / BASE SETTINGS

9.6.1. SET THE BASE TO PAIRING MODE

•Go to SETTINGS / ADVANCED SET. / SET BASE / REGISTR. MODE.

• Your base light then starts to flash red rapidly.

• Your base will remain in registration mode for about 1 minute.

9.6.2. RESETTING THE BASE

When you reset your base, all the base parameters are reset to their initial values (factory

settings).

•Go to SETTINGS / ADVANCED SET. / SET BASE / RESET BASE.

•Press Yes .

• Enter the base code. Press OK.

The “RE-INIT. IN PROGRESS message is displayed.

9.6.3. DE-REGISTERING A HANDSET

•Go to SETTINGS / ADVANCED SET. / SET BASE / DELETE HANDSET.

• Select the handset you wish to unregister, press OK.

• A screen prompts you to confirm the unregistration. Press Yes to unregister the

handset.

9.7. ADVANCED SETTINGS / LINE SETTINGS

You can also set the base to pairing mode by holding down your base’s

button.

You can save up to four GAP-compatible handsets on your CC220R base.

Before changing the settings of the telephone line, contact your operator to

obtain the parameters for your line.