User's Manual
Table Of Contents
- SX682 WiMAX
- User Guide - User
- Contents
- For your safety
- SX682 WiMAX
- Installing the SX682 WiMAX
- Configuration with the Web browser
- Basic Setup Wizard
- Advanced Settings
- Administration
- Status
- Using the SX682 WiMAX
- Appendix
- Glossary
- Index
58
Confirmation tones
SX682 WiMAX / engbt / SX682_FUG_EN_9 / Operation.fm / 17.5.11
Schablone 2011_04_07
Confirmation tones
If you execute one of the actions listed in section "Call forwarding" on page 57 you will
hear a confirmation tone. The confirmation tone sounds even if the action doesn’t make
sense, e.g. if you try to activate a feature that is already activated. After a confirmation
tone you must hang up the receiver before you can execute another action or before
you can telephone.
Action: Deactivating "Forwarding on no response"
Press the star key and then the keys 4 and 1.
Call forwarding on no response will be deactivated.
Action: Deactivating call forwarding in all cases
Press the star key and then press twice the key 1.
All call forwarding settings will be deactivated.
Confirmation tone: Call forwarding is activated and an incoming call is forwarded.
If you are at home this signal will remind you that call forwarding
is activated.
Sutter-dial tone
(short signal tone)
Call forwarding is activated and you lift the receiver.
i
The confirmation tones can be configured by the operator.