User's Manual
Table Of Contents
- SE681 WiMAX
- User Guide - User
- Contents
- For your safety
- SE681 WiMAX
- Installing the SE681 WiMAX
- Configuration with the Web browser
- Basic Setup Wizard
- Advanced Settings
- Administration
- Status
- Using the SE681 WiMAX
- Appendix
- Glossary
- Index
11
Product overview
SE681 WiMAX / engbt / SE681_FUG_EN_9 / Product_intro.fm / 18.5.11
Schablone 2011_04_07
RSSI:
signal quality
0 to 4 LEDs light
up green
The LEDs on the SE681 WiMAX help you to
position the antenna more easily. The LEDs
indicate the signal quality; the more LEDs
that light up, the better the signal reception.
All 4 LEDs flash
green
The SE681 WiMAX is being reset to the fac-
tory settings; see "Returning the SE681
WiMAX to factory settings" on page 18.
i
The connection quality can be detected in two different ways:
CINR (Carrier to Interference and Noise Ratio) measures the signal
quality.
RSSI (Received Signal Strength Indication) measures the signal
strength.
The LEDs indicate either RSSI or CINR values. The used method is pre-
configured by your operator. If RSSI is used the RSSI 1 - RSSI 4 LEDs
will show the signal strength.
Name LED Meaning