User's Manual

23
Advanced Settings
SE680 WiMAX / engbt / SE680_FUG_EN-7 / Advanced_configuration.fm / 13.5.11
Schablone 2011_04_07
Advanced Settings
In the Advanced Settings menu, you can configure all the options for the SE680
WiMAX. If required, you can also change the settings you made using the Basic Setup
Wizard. The following table contains the options available in this menu.
All Advanced Settings pages contain Ok and Cancel buttons.
 Click Ok to confirm your entries.
 Click Cancel to close a page without applying the changes.
Menu Description
Operating Mode
Here you can define whether your SE680 WiMAX will be
used as a router or a bridge for the Internet access
(page 24).
Internet
Here you can configure your Internet access. This menu
covers all setting options for the Internet (page 25).
Local Network Here you can configure your local network, e.g. change the
private IP address of the SE680 WiMAX or make settings
for the DHCP server (page 29).
WiMAX configuration Here you can change the access data for your WiMAX
access (page 30).
Administration Here you can do various administration tasks, e.g. assign a
system password (page 31) or reset the configuration to the
factory defaults (page 32). You can also load new firmware
(page 33)
i
Depending on the pre-configuration of your device some of the menu
entries and configuration possibilities might be missing in your device.