User's Manual

page 56/64
Note d’étude / Technical document : URD1– OTL
5665.3 – 003 / 72238 Edition 01
Document Sagemcom Reproduction et divulgation interdites
Sagemcom document. Reproduction and disclosure prohibited
Figure 57 : Laboratory hot plate to unsolder the module

Customer must remember to not have components on the HiLoNC V2 opposite side of the customer’s
board.
11. LABEL
The HiLoNC V2 module is labelled with its own FCC ID(TBD) on the shield side. When the module is installed in
customer’s product, the FCC ID label on the module will not be visible. To avoid this case, an exterior label must
be stuck on the surface of customer’s product signally to indicate the FCC ID of the enclosed module. This label
can use wording such as the following: “Contains Transmitter module FCC ID: TBD” or “Contains FCC ID:
TBD”.
Electronic board
HiLoNC
Cube to
concentrate
the heat
Unsoldering hot
plate