User's Manual

page 48/64
Note d’étude / Technical document : URD1– OTL
5665.3 – 003 / 72238 Edition 01
Document Sagemcom Reproduction et divulgation interdites
Sagemcom document. Reproduction and disclosure prohibited
9.1.3 Clocks

Clock signals must be shielded between two grounds layer and bordered with ground vias.
9.1.4 Data bus and other signals

Data bus and commands have to be routed on the same layer; none of the lines of the bus shall be
parallel to other lines

Lines crossing shall be perpendicular

Suitable other signals track width, thickness.

Data bus must be protected by upper and lower ground plans
9.1.5 Radio

Provide a 50 Ohm micro strip line for antenna connection
9.1.6 Audio

Differential signals have to be routed together, parallel (for example HSET_OUT_P/HSET_OUT_N).

Audio signals have to be isolated, by pair, from all the other signals (ground all around each pair).

Cancel any loops between VBAT and GND next to the speaker to avoid the TDMA burst noise in the
speaker during a communication.

The single-end audio signal should be adopted the same rules as differential signals.
Figure 47: Layout of audio differential signals on a layer n
Figure 48: Adjacent layers of audio differential signals
Layer n-1
Layer n
Layer n+1
GND
HSET_OUT_P
GND
GND
HSET_OUT_P
GND
HSET_OUT_N