User's Manual

page 23/35
Note d’étude / Technical document : URD1– OTL 5665.1– 002 / 70 884 Edition 03
Document Sagem Communications Reproduction et divulgation interdites
Sagem Communications document. Reproduction and disclosure prohibited
When AT+KSLEEP=1 is configured :
• the HiloNC module decides by itself when it enters in sleep mode (no more task running).
• “0x00” character on serial link wakes up the HiloNC module.
When AT+KSLEEP=0 is configured :
• the HiloNC module is active when DTR signal is active (low electrical level).
• when DTR is deactivated (high electrical level), the HiloNC module enters in sleep mode after a while.
• on DTR activation (low electrical level), the HiloNC module wakes up.