User's Manual

page 16/35
Note d’étude / Technical document : URD1– OTL 5665.1– 002 / 70 884 Edition 03
Document Sagem Communications Reproduction et divulgation interdites
Sagem Communications document. Reproduction and disclosure prohibited
3.5.3 Example 3
Simple boost converter with Linear LT1913 (see LT1316 evaluation kit document).
Figure 11: Example with Linear LT1913
3.6 V24
The HiloNC module features a V24 interface to communicate with the Host through AT commands or for easy
firmware upgrading purpose.

It is recommended to manage an external access to the V24 interface, in order to allow easy software
upgrade (baud rate up to 460.8kbps, validated with ATEN USB/Serial converter).

Pull-up resistors must be connected to DCD, DSR and RI signals if these signals are used.
3.6.1 Complete V24 – connection HiloNC - host
A V24 interface is provided on the 51 pads of the HiloNC module with the following signals: RTS/CTS, RXD/TXD,
DSR, DTR, DCD, RI.