User's Manual
URD1
– OTL 5696.1–
022
/ 72740 Edition 0.4
HILONC-
3GPS
APPLICATION
NOTE
1.
OVERVIEW
1.1.
Document
Objectives
The aim of this document is to provide examples of hardware solutions for development of products based
around the Sagemcom HiLo NC-3GPS Module. Most of these solutions are not mandatory. Use them as
suggestions
of
what
should
be
done
to
achieve
a
working
product
and
what
should
be
avoided
according
to
our
own experiences.
This
document
gives
suggestions
on
how
to
integrate
the
HiLo
NC-3GPS
module
into
devices
for
automotive
applications,
AMM
(Automatic
Metering
Management),
tracking
systems;
including
connection
with
external
devices, layout advic
es,
external
components
(decoupling
capacitors…),
etc.
1.2.
Reference
Documents
[1] URD1 OTL 5696 3 001 72497- HILONC-3GPS technical specifications
[2] URD1 OTL 5696.1 006 72370- AT Command Set for SAGEM HILONC-3GPS Modules
1.3.
Document
Modifications
The
information
presented
in
this
document
should
be
accurate
and
reliable.
However
Sagemcom
assumes
no
responsibility
for
its
use,
nor
any
infringement
of
patents
or
other
third
party
rights
which
may
result
from
its
use.
This document is subject to change without notice.
Changes
or
modifications
not
expressly
approved
by
the
party
responsible
for
compliance
could
void
the
user’s
authority to operate the equipment.
1.4.
Conventions
SIGNAL
NAMES:
All signal names written on the pins of the HILONC-3GPS module are in
italics
.
Special attention must be paid to the information on them.
2.
Block
Diagram
Note d’étude / Technical document :
01/08/20111
-
Page
6
/
41