User's Manual
URD1
– OTL 5696.1–
022
/ 72740 Edition 0.4
HILONC-
3GPS
APPLICATION
NOTE
10.8
Hand
soldering
Hand soldering is impossible for HILONC-3GPS.
10.9
Unsoldering
Manual unsoldering is possible, for repair purpose for example.
A special care must be considered in order to avoid overheating the HILONC-3GPS.
For repairing: Usage of hot plate like example below can be considered with additional metallic cubic plate
whose dimensions are HILONC-3GPS's ones (to heat only HILONC-3GPS surface)
Customer must remember to not have components on the HILONC-3GPS opposit
e
side
of
the
customer’s
board.
11.
Labelling
The
HILONC-3GPS
module
is
labeled
with
its
own
FCC
ID
(XXXHILONC-3GPS)
on
the
shield
side.
When
the
module
is
installed
inside
customer’s
product,
the
FCC
ID
label
on
the
module
will
not
be
visible.
To
avoid
this
scenario
an
exterior
label
must
be
stuck
on
the
surface
of
the
customer’s
product
to
indicate
the
FCC
ID
of
the
enclosed
module.
The
label
can
use
the
following
wording:
“Contains
transmitter
module
FCC
ID:
XXXHILONC-
3GPS
”
or
“Contains
FCC
ID:
XXXHILONC-3GPS
”.
12.
CE/FCC/IC
warning
statement
Europe
–
EU
Declaration
of
Conformity
This device complies with the essential requirements of the R&TTE Directive 1999/5/EC. The following test
methods
have
been
applied
in
order
to
prove
presumption
of
conformity
with
the
essential
requirements
of
the
R&TTE Directive 1999/5/EC:
- EN 60950-1: 2006+A11:2009:+A1:2010+A12:2011
Safety of Information Technology Equipment
- EN 301 908-2 V5.2.1
- EN 62311: 2008
Assessment of electronic and electrical equipment related to human exposure restrictions for
electromagnetic fields (0 Hz-300 GHz)
(IEC 62311:2007 (Modified))
- EN 301 908-1 V4.2.1
-
Electromagnetic
compatibility
and
Radio
spectrum
Matters
(ERM);
Base
Stations
(BS),
Repeaters
and
User
Equipment
(UE)
for
IMT-2000
Third-Generation
cellular
networks;
Part
1:
Harmonized
EN
for
IMT-2000,
introduction and common requirements, covering essential requirements of article 3.2 of the R&TTE
Directive
- EN 301 511 V9.0.2: 2003
Note d’étude / Technical document :
01/08/20111
-
Page
35
/
41