User's Manual

page 49/51
HiAll
NC
User Manual 2012/06/28
10.2 EXAMPLE OF LAYOUT FOR CUSTOMER’S BOARD
The following figure is an example of layer allocation for a 6 layers circuit (for reference purpose only):
Depending on the customer’s design, the layout could also be 4 layers.
Figure 32: 6 layers PCB stack-up
11. LABEL
The HiAll
NC
module is labelled with its own FCC ID (VW3HIALLNC) on the shield side. When the module is
installed in customer’s product, the FCC ID label on the module will not be visible. To avoid this case, an
exterior label must be stuck on the surface of customer’s product signally to indicate the FCC ID of the enclosed
module. This label can use wording such as the following: “Contains Transmitter module FCC ID:
VW3HIALLNC” or “Contains FCC ID: VW3HIALLNC ”.
12. FCC LEGAL INFORMATION
12.1 FCC REGULATIONS
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.